Cursor
(Difference between revisions)
(→Components) |
|||
| Line 6: | Line 6: | ||
The system consists of | The system consists of | ||
| − | * a chariot assembly | + | * a [[Media:Cursor_chariot_assembly.pdf|chariot assembly]] |
| − | * an FPGA prototyping board | + | * an [http://wiki.hevs.ch/uit/index.php5/Hardware/FPGAEBS FPGA prototyping board] |
* a control board with 4 buttons and 8 LEDs | * a control board with 4 buttons and 8 LEDs | ||
=== DC motor === | === DC motor === | ||
| − | The DC motor is controlled by a [[Media:L6207N.pdf|L6207 H-bridge driver | + | |
| + | The DC motor is controlled by a [[Media:L6207N.pdf|L6207]] H-bridge driver. | ||
Revision as of 12:41, 20 November 2012
|
The cursor project is an ElN project done at the end of the first semester. It consists in driving a DC motor which moves the cursor chariot with the help of a screw.
Components
The system consists of
- a chariot assembly
- an FPGA prototyping board
- a control board with 4 buttons and 8 LEDs
DC motor
The DC motor is controlled by a L6207 H-bridge driver.
