The Kart module (214_Pr1) is a Summer School module for students between the 2nd and the 3rd semester. It is a home-made model car remotely controlled by a smartphone.
The work of the students can be summarized in four main tasks:
- design and assembly of the chassis
- analysis of the motor driver circuits (DC and stepper)
- configuration of the controlling FPGAs
- completion and extension of the control GUI on the smartphone
The kart is controlled by a smartphone via Bluetooth.
A Bluetooth receiver on the kart communicates via an RS232 serial link with the FPGA control board. This board stores the control values in a set of registers and dispatches them at a regular interval on an I2C link. The master also reads data values from the slave boards, stores them into a second set of registers and sends the corresponding information at a regular pace over the RS232 with a very simple protocol.
The control is distributed over several FPGA boards connected together via I2C. These base boards each hold a slave function board:
- A Bluetooth RS232 modem sits on the I2C master FPGA
- A DC motor controller receives a speed value and builds a PWM and a direction control.
- A stepper motor controller receives the desired angle and builds the coil controls signals.
- A sensor board manages I/O comprising proximity sensors, hall sensors (for the driving speed) and LEDs.
The programming introduction gives an overview about the structure of the software/hardware and the students' tasks. They comprise:
- FPGA design for driving the hardware and reading the sensors
- Android application development for the remote control
The students receive FPGA boards preprogrammed with a functional solution and androïd phones with a demo application. This allows to start the development either with the FPGA design or the Android application development.
A FPGA design environment is available, based on:
- HDL designer for graphical design entry
- ModelSim for simulation
- Libero IDE for synthesis and programming
With this, the following designs have to be completed:
- the DC motor controller FPGA has to generate the PWM and direction signals for the propulsion motor
- the stepper motor controller FPGA has to generate the 4 phases to turn the steering wheels to the desired angle
- the I/O control FPGA has to count the propulsion wheels' rotations and can count the ultrasound ranger distance.
One goal is to implement an Android application that controls and monitors the kart.
The installable package of the (or rather a) solution can be found here: Kart.apk
An introduction to Android can be found here: Android Introduction
Another sample project to learn how to create vertical seek bars: Vertical SeekBar Example
You can download the Kart project with the minimal interface here: Kart.zip
You can find the instructions how to open the project in Android Studio in the "Programming Indtroduction" presentation...
The online documentation of all Java classes that are at your disposition is [here]
The power supply board provides the 5 V and the 3.3 V to the other boards. This is generated from two 6 V battery packs.
The power supply board also comprises an ADC which provides the battery level.
The FPGA motherboards can be tested with the help of a dedicated test board which runs a signal from one I/O pin to the next.
Existing daughterboards are:
- a Bluetooth interface board
- a DC motor controller
- a stepper motor controller
- an I/O board for the sensors
- an FPGA test board
The sensors connected to the I/O board are:
- 1 to 4 VCNL4000 I2C Distance/Ambience Light Sensor
- 1 to 2 SS311PT Hall Sensor
- 1 ultrasound ranger
- 1 end of turn contact switch