|Line 58:||Line 58:|
| signal ()
Revision as of 14:20, 15 June 2015
Inputs and outputs
End of turn switch
The end of turn switch is located in the I/O board's middle row. It is the 4-pin connector closest to the 5-pin connector. The switch cable is to be connected as:
cable pin green 5 V power supply yellow input
The input has a pull-down resistor. Closing the switch brings a logic '1'.
The sensor connectors are located in the I/O board's middle row. The sensor cable is to be connected as:
cable pin red 3.3 V or 5 V power supply brown sensor signal black ground
The sensor connectors are located in the I/O board's middle row. It is the single 5-pin connector. The sensor cable is to be connected as:
cable pin red 5 V power supply yellow measurement start (trig) green distance signal (in) black ground
The sensor connectors are located in the I/O board's side row.
The sensor cable is to be connected as:
cable pin orange 3.3 V power supply yellow SDA green SCL blue ground
The board has 4 LED outputs which can also be used for other purposes, such as buzzers.
The outputs have a common power supply, 2 resistor mount holes and a 2-pin LED connector located on the I/O board's bottom row.
The power supply is connected directly to the 12 V battery packs. The resistor is connected between the power supply and the LED. The LED is connected between the resistor and the ground.
One or two Hall sensors are used to track the distance driven by the kart. An ultrasound ranger can detect if there is an obstacle at the front of the kart.
To begin with, the design environment has to be downloaded.
It comprises the
sensorsInterface block which contains the provided I2C bus interface,
and an empty
ultrasoundRanger block which are to be designed.
The block receives a
hallPulses signal array, one per hall pulse sensor.
For each of these inputs, it requires a counter.
The counter values are concatenated to build the
The ultrasound ranger receives a trigger signal,
startMeasure, and sends an ultrasound pulse.
Once the pulse is sent, the sensor drives
distancePulse to '1' as long as it hasn't received any echo.
The circuit has to count the length of the sequence in terms of clock pulses and returns the value on