Hardware/8CH4IOHFAnalogMuxBoard
(Difference between revisions)
m (→Power supply / driving considerations) |
m (→Power supply / driving considerations) |
||
Line 32: | Line 32: | ||
The following signals can be found on the connector :<TABLE MISSING> | The following signals can be found on the connector :<TABLE MISSING> | ||
+ | [[File:MFS_ANALOGMUX_CONNECTOR.png|Connector]] | ||
= Changelog / Known issues = | = Changelog / Known issues = |
Revision as of 13:03, 24 August 2016
|
This general purpose board was created for high quality analog muxing/demuxing for demanding measurement applications.
Characteristics
- 256x100mm 8 layers PCB
- 8 <-> 1 channels
- 4 I/O per channels (ground commuted with the signal, so no common ground)
- Bandwidth : 0...200MHz (best use : 0...10MHz, see plot below)
- SMA or SMB connectors
- Signal relay based solution
- Balanced tree routage (same trace distance for any commuted channel)
- 50Ohms impedance controlled shielded coaxial traces
- 1x LED per channel (light when selected) + 1x power LED.
- 1x 2mm-pitched 2x6 connector.
Power supply / driving considerations
This board doesn't have any driving circuit on it.
Actually, there is 3 ways to drive the board :
- A basic FPGA board, MFSRELAYCTRL, for HVME16 or any other control buses.
- It can be driven with a NI USB box through a driver board too.
- Finally, active channel can be manually switched via a basic switches box.