Hardware/CubeSat Gumstix/Test/OV7670 config

From UIT
Revision as of 13:37, 9 December 2015 by Francois.corthay (Talk | contribs)
Jump to: navigation, search

Contents

The OV7670 camera can be configures for different image sizes and frame rates.

Cubesat ADC test board connections.JPG

Configuration

An RS232 interface allows to send configuration commands to the camera.

Power-up settings

At power-up, the test system sets the camera in 352 × 288 CIF mode with RGB output.

The following table provides the register write sequence:

address data comment
12 80 COM7: reset
12 24 COM7: CIF resoultion, RGB
11 40 CLKRC: no clock prescaling

Connection

The camera is connected to the camera interface connector:

connector
pin
signal FPGA
pin
function
1 3.3 V power supply
2 GND
3 SClk A4 I2C control
4 SDa B10
5 VSync A5 frame control
6 HRef C5
8 Pixel clock A10
22 XClk C14 camera control
23 CC3 / Reset B14
24 CC4 / PowerDn D14

The serial port is found on the peripheral 2 connector:

connector
pin
signal FPGA
pin
function
1 3.3 V power supply
2 GND
3 TxD L1 Serial port
4 RxD L3

User interface

In a terminal program:

  • typing a "r" launches the initialisation sequence again; the console prints an "r" in return to acknowledge the command
  • typing 4 hex digits allow to enter a register address and value; the console prints an "v" in return to acknowledge the command
Personal tools
Namespaces
Variants
Actions
Navigation
Browse
Toolbox