Hardware/FPGAEBS/Configuration

(Difference between revisions)
Jump to: navigation, search
(Flash Writing)
Line 47: Line 47:
  
 
= Flash Writing =
 
= Flash Writing =
<!--
 
To program the FLASH you need to turn your *.bit into a *.mcs files witch can then be programmed through the FPGA into the Flash.
 
  
Flash programmation works '''ONLY with Official Xilinx USB Programmer'''
+
To program the ''xcf04s'' Platform Flash In-System Programmable Configuration PROM you need to turn your *.bit into an *.mcs file. This file can then be used to program the Platform Flash through JTAG.
 +
 
 +
<!--Flash programming works '''ONLY with Official Xilinx USB Programmer'''
 
== Create Flash *.mcs File ==
 
== Create Flash *.mcs File ==
 
# Choose Task '''Create PROM File'''
 
# Choose Task '''Create PROM File'''

Revision as of 21:34, 30 September 2013

Contents

General

After designing and simulating your design based on VHDL Template Design, you have to prepare it:

  1. In HDL-Designer: Perform Task Flow Prepare for Synthesis
    1. Generates all VHDL Files
    2. Concatenates them into a single VHDL File
    3. Trims work libraries
  2. In HDL-Designer: Perform Task Flow Xilinx Project Navigator
    1. Updates the ISE (*.xise) Project file
    2. Launches ISE
  3. In ISE: Perform Task Generate Programming File
    1. Runs Synthesis
    2. Runs P&R
    3. Generate Programming File *.bit
  4. In ISE: Perform Task Configure Target Device
    1. Launches Impact

After that you can either way download the file directly to the FPGA or create another file to download to the non-volatile memory.

FPGA Configuration

Flash Writing

To program the xcf04s Platform Flash In-System Programmable Configuration PROM you need to turn your *.bit into an *.mcs file. This file can then be used to program the Platform Flash through JTAG.

Personal tools
Namespaces
Variants
Actions
Navigation
Browse
Toolbox