Kart/stepper motor controller
(Difference between revisions)
(→Stepper motor) |
(→FPGA design) |
||
Line 34: | Line 34: | ||
== FPGA design == | == FPGA design == | ||
− | The stepper motor controller has to generate the 4 phases to turn the steering wheels to the desired angle. | + | The stepper motor controller has to generate the 4 phases to turn the [[Kart|kart's]] steering wheels to the desired angle. |
+ | |||
+ | To start, [[Kart#FPGA_Design|the design environment]] has to be downloaded. | ||
[[Category:Kart]] | [[Category:Kart]] |
Revision as of 14:22, 9 June 2015
|
The stepper motor controller FPGA generates 4 coil driving signals and receives a stepper end input.
Stepper motor
The stepper motor is a Nanotec SP3575M0906-A.
It has a step angle of 7.5°, and as such 48 steps per turn.
The cables are connected as follows:
Signal | Color |
---|---|
phase 1 | white |
phase 2 | blue |
phase 3 | red |
phase 4 | yellow |
power | brown, black |
FPGA design
The stepper motor controller has to generate the 4 phases to turn the kart's steering wheels to the desired angle.
To start, the design environment has to be downloaded.