Hardware/ARMEBS/4/DFU
From UIT
|
The USB specification defines a mode for updating USB device called DFU (Device Firmware Update), see 1.1 specification.
DFU on the ARMEBS4
- The DFU mode can be activated by moving the "boot0" jumper, near the reset button.
boot0 Jumper | Effect |
Not soldered Not connected Left |
Normal mode |
Right |
DFU mode |
- Then press the reset button
dfu-util
This command :
dfu-util -a 0 -d 0483:df11 -s 0x08000000:leave -D leds.bin
Will flash the leds.bin
on the ARMEBS4 then run the code.
.bin
file generation
FIXME