Hardware/ARMEBS/4/DFU
(Difference between revisions)
(→dfu-util) |
|||
| Line 17: | Line 17: | ||
=== <code>.bin </code> file generation === | === <code>.bin </code> file generation === | ||
| + | FIXME | ||
Revision as of 15:45, 17 September 2014
|
FIXME finish this page
The USB specification defines a mode for updating USB device called DFU (Device Firmware Update), see 1.1 specification.
The microcontroler on the ARMEBS4 board supports this protocol.
dfu-util
This command :
dfu-util -a 0 -d 0483:df11 -s 0x08000000:leave -D leds.bin
Will flash the leds.bin on the ARMEBS4 then run the code.
.bin file generation
FIXME
