Hardware/ARMEBS/4/DFU

The USB specification defines a mode for updating USB device called DFU (Device Firmware Update), see 1.1 specification.

DFU on the ARMEBS4

1. The DFU mode can be activated by moving the "boot0" jumper, near the reset button.

boot0 Jumper	Effect
Not soldered Not connected Left	Normal mode
Right	DFU mode

1. Then the reset button

dfu-util

This command :

dfu-util -a 0 -d 0483:df11 -s 0x08000000:leave -D leds.bin

Will flash the leds.bin on the ARMEBS4 then run the code.

.bin file generation

FIXME