Kart/sensors/SS311PT
(→Kart connection) |
(→Kart connection) |
||
Line 20: | Line 20: | ||
The sensor connectors are located in the I/O board's middle row. | The sensor connectors are located in the I/O board's middle row. | ||
The sensor cable is to be connected as: | The sensor cable is to be connected as: | ||
− | + | {| cellpadding="3" cellspacing="0" border="1" | |
− | + | ! cable | |
− | + | ! pin | |
+ | |- | ||
+ | | red | ||
+ | | 3.3 V or 5 V power supply | ||
+ | |- | ||
+ | | brown | ||
+ | | sensor signal | ||
+ | |- | ||
+ | | black | ||
+ | | ground | ||
+ | |} | ||
[[Category:Kart]] | [[Category:Kart]] |
Revision as of 11:41, 21 July 2014
|
HONEYWELL S&C - SS311PT - SENSOR, HALL EFFEKT, BIPOLAR, SOT-23
The SS311PT/SS411P sensors are small, versatile digital Hall- effect devices that are operated by the magnetic field from a permanent magnet or an electromagnet, designed to respond to alternating North and South poles. These bipolar sensors have enhanced sensitivity which allows for the use of smaller, often less expensive magnets. The internal pull-up resistor often eliminates the need for external components, further helping to reduce system cost. These economical bipolar sensors are suited for many simple, high- volume, cost-sensitive, rotary sensing applications. The 2.7 Vdc to 7 Vdc supply voltage range allows this device to be used in low voltage applications.
Datasheet on Farnell: http://www.farnell.com/datasheets/524505.pdf
- Manufacturer: HONEYWELL S&C
- Farnell: 1784726
- Manufacturer Desc: SS311PT
Output
Open collector output with integrated 10k Ohms Pull-Up resistor.
Kart connection
The sensor connectors are located in the I/O board's middle row. The sensor cable is to be connected as:
cable | pin |
---|---|
red | 3.3 V or 5 V power supply |
brown | sensor signal |
black | ground |