Cursor
(Difference between revisions)
Line 15: | Line 15: | ||
The DC motor is controlled by a [[Media:L6207N.pdf|L6207]] H-bridge driver. | The DC motor is controlled by a [[Media:L6207N.pdf|L6207]] H-bridge driver. | ||
+ | |||
+ | == Toplevel Design == | ||
+ | In prior to create the Cursor Programm you should take the time and create a toplevel bloc structure. Use the File below for drawing, all In and Outputs of the design can be found there. | ||
+ | |||
+ | [[Media:Cursor_Toplevel_Empty.pdf|Empty Toplevel Design]] |
Revision as of 17:06, 21 November 2012
|
The cursor project is an ElN project done at the end of the first semester. It consists in driving a DC motor which moves the cursor chariot with the help of a screw.
Components
The system consists of
- a chariot assembly
- an FPGA prototyping board
- a control board with 4 buttons and 8 LEDs
DC motor
The DC motor is controlled by a L6207 H-bridge driver.
Toplevel Design
In prior to create the Cursor Programm you should take the time and create a toplevel bloc structure. Use the File below for drawing, all In and Outputs of the design can be found there.