Kart/sensor board
From FSI
Revision as of 11:03, 25 July 2014 by Francois.corthay (Talk | contribs)
|
End of turn switch
The end of turn switch is located in the I/O board's middle row. It is the 4-pin connector closest to the 5-pin connector. The switch cable is to be connected as:
cable | pin |
---|---|
green | 5 V power supply |
yellow | input |
The input has a pull-down resistor. Closing the switch brings a logic '1'.
Hall sensors
The sensor connectors are located in the I/O board's middle row. The sensor cable is to be connected as:
cable | pin |
---|---|
red | 3.3 V or 5 V power supply |
brown | sensor signal |
black | ground |
Ultrasound ranger
The sensor connectors are located in the I/O board's middle row. It is the single 5-pin connector. The sensor cable is to be connected as:
cable | pin |
---|---|
red | 5 V power supply |
yellow | measurement start (trig) |
green | echo signal (distance) |
black | ground |
Proximity sensors
The sensor connectors are located in the I/O board's side row.
The sensor cable is to be connected as:
cable | pin |
---|---|
orange | 3.3 V power supply |
yellow | SDA |
green | SCL |
blue | ground |