Hardware/FPGARackDebug
From UIT
(Difference between revisions)
Line 15: | Line 15: | ||
|} | |} | ||
− | The complete VME bus configuration is already stored within the [[Inventory/Measurement/LogicAnalyzer#Agilent_16803A|Agilent 16803A Logic Analyzer]]. In order to use it connect the Agilent E5385A Probes as | + | The complete VME bus configuration is already stored within the [[Inventory/Measurement/LogicAnalyzer#Agilent_16803A|Agilent 16803A Logic Analyzer]]. In order to use it connect the Agilent E5385A Probes as shown below and load the following configuration: ''C:\Documents and Settings\analyser\My Documents\Agilent Tehcnologies\Logic Analyzer\Config Files\BasMI_HVME.ala'' |
[[File:FPGARack_Debug_Board_connected.jpg|500px|FPGA Rack Debug Board ConnectedV1.0]] | [[File:FPGARack_Debug_Board_connected.jpg|500px|FPGA Rack Debug Board ConnectedV1.0]] | ||
[[Category:Hardware]] [[Category:FPGARack]] [[Category:VME]] | [[Category:Hardware]] [[Category:FPGARack]] [[Category:VME]] |
Latest revision as of 16:08, 27 January 2014
This boards allows to Debug easily the VME bus. All signals can be connected directly with the Agilent E5385A Probe to the Agilent 16803A Logic Analyzer
With the help of 2 Agilent Probes almost all (4x16=64Pins) necessary signal can be connected the the Analyzer.
Type | Debug Board | Schematic | Description |
---|---|---|---|
V1.0 | FPGA Rack Debug v1.0 Schematic PDF | Debug Board. Note that the connector is mounted in reverse because of PCAD Library problems |
The complete VME bus configuration is already stored within the Agilent 16803A Logic Analyzer. In order to use it connect the Agilent E5385A Probes as shown below and load the following configuration: C:\Documents and Settings\analyser\My Documents\Agilent Tehcnologies\Logic Analyzer\Config Files\BasMI_HVME.ala