Hardware/ARMEBS/4/DFU
From UIT
(Difference between revisions)
(Created page with "{{public}} {{TOC right}} The USB specification defines a mode for updating USB device called DFU (Device Firmware Update), see [http://www.usb.org/developers/docs/devclass_doc...") |
|||
| (4 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
{{public}} | {{public}} | ||
{{TOC right}} | {{TOC right}} | ||
| − | The USB specification defines a mode for updating USB device called DFU (Device Firmware Update), see [http://www.usb.org/developers/docs/devclass_docs/DFU_1.1.pdf|DFU 1.1 specification] | + | |
| + | The USB specification defines a mode for updating USB device called DFU (Device Firmware Update), see [http://www.usb.org/developers/docs/devclass_docs/DFU_1.1.pdf|DFU 1.1 specification]. | ||
| + | |||
| + | == DFU on the ARMEBS4 == | ||
| + | # The DFU mode can be activated by moving the "boot0" jumper, near the reset button. | ||
| + | {|class=wikitable | ||
| + | |- | ||
| + | | boot0 Jumper || Effect | ||
| + | |- | ||
| + | || | ||
| + | Not soldered | ||
| + | |||
| + | Not connected | ||
| + | |||
| + | Left | ||
| + | || Normal mode | ||
| + | |- | ||
| + | || | ||
| + | Right | ||
| + | || DFU mode | ||
| + | |} | ||
| + | |||
| + | # Then press the reset button | ||
| + | |||
| + | == dfu-util == | ||
| + | This command : | ||
| + | |||
| + | |||
| + | <code>dfu-util -a 0 -d 0483:df11 -s 0x08000000:leave -D leds.bin</code> | ||
| + | |||
| + | Will flash the <code>leds.bin</code> on the ARMEBS4 then run the code. | ||
| + | |||
| + | === <code>.bin </code> file generation === | ||
| + | FIXME | ||
Latest revision as of 11:43, 18 September 2014
|
The USB specification defines a mode for updating USB device called DFU (Device Firmware Update), see 1.1 specification.
DFU on the ARMEBS4
- The DFU mode can be activated by moving the "boot0" jumper, near the reset button.
| boot0 Jumper | Effect |
|
Not soldered Not connected Left |
Normal mode |
|
Right |
DFU mode |
- Then press the reset button
dfu-util
This command :
dfu-util -a 0 -d 0483:df11 -s 0x08000000:leave -D leds.bin
Will flash the leds.bin on the ARMEBS4 then run the code.
.bin file generation
FIXME
