Tools/Laser cutter
From UIT
(Difference between revisions)
(Created page with "{{TOC right}} The HEI owns 2 laser cutting machines: * a 40 W xxx in Axxx * a xx W xxx in Cxxx The machines are seen as printers. The xxx printer driver allows to ...") |
(→From Inkscape) |
||
(3 intermediate revisions by one user not shown) | |||
Line 2: | Line 2: | ||
The HEI owns 2 laser cutting machines: | The HEI owns 2 laser cutting machines: | ||
− | * a 40 W xxx in | + | * a 40 W xxx in AE07 |
* a xx W xxx in Cxxx | * a xx W xxx in Cxxx | ||
Line 14: | Line 14: | ||
* Make sure to have everything drawn to the base colors known by the printer. | * Make sure to have everything drawn to the base colors known by the printer. | ||
− | * Set-up the page size to match the pint bed's | + | * Set-up the page size to match the pint bed's: |
+ | ** AE07 is 470 x 305 | ||
+ | * Defaulr setup: | ||
+ | ** red cuts | ||
+ | ** black engraves | ||
* '''Transform all the lines foreseen for cutting to a width smaller than 0.01 mm.''' | * '''Transform all the lines foreseen for cutting to a width smaller than 0.01 mm.''' | ||
* Save the drawing as a PDF and open it with a PDF viewer. | * Save the drawing as a PDF and open it with a PDF viewer. | ||
Line 21: | Line 25: | ||
* power-on the laser cutter | * power-on the laser cutter | ||
− | * in | + | * in AE07 (only ?) power-on the ventilation system (switch on the table's leg) |
* print the file, verify the printer settings | * print the file, verify the printer settings | ||
− | * the laser should show it has | + | * the laser should show it has received the file |
* press the green button to start | * press the green button to start |
Latest revision as of 14:07, 27 August 2020
|
The HEI owns 2 laser cutting machines:
- a 40 W xxx in AE07
- a xx W xxx in Cxxx
The machines are seen as printers. The xxx printer driver allows to transfer the drawings to the laser cutter. The printer driver recognizes xxx specific colors which are translated into laser power and speed values.
Preparing for print
From Inkscape
- Make sure to have everything drawn to the base colors known by the printer.
- Set-up the page size to match the pint bed's:
- AE07 is 470 x 305
- Defaulr setup:
- red cuts
- black engraves
- Transform all the lines foreseen for cutting to a width smaller than 0.01 mm.
- Save the drawing as a PDF and open it with a PDF viewer.
Printing
- power-on the laser cutter
- in AE07 (only ?) power-on the ventilation system (switch on the table's leg)
- print the file, verify the printer settings
- the laser should show it has received the file
- press the green button to start