Hardware/Interfaces
(Difference between revisions)
(→USB to CAN interface) |
m (→USB to CAN interface) |
||
Line 10: | Line 10: | ||
On this pin, you can draw a current of 300 [mA]. | On this pin, you can draw a current of 300 [mA]. | ||
==== Modifications details ==== | ==== Modifications details ==== | ||
− | A wire has been added to place the USB voltage on DB-9 pin 9. | + | A wire has been added to place the USB voltage on DB-9 pin 9. |
A 0 [ohms] resistor has been added to connect the CAN_GND with the supply GND. | A 0 [ohms] resistor has been added to connect the CAN_GND with the supply GND. | ||
+ | |||
[[File:Usb can modif.JPG|261px|Modifications]] | [[File:Usb can modif.JPG|261px|Modifications]] | ||
=== User DB-9 connector === | === User DB-9 connector === |
Revision as of 10:42, 14 February 2013
|
USB to CAN interface
USB TO CAN interface from IXXAT
The drivers and some tools are available from the constructor :IXXAT USB-to-CAN Webpage
HEIV modifications
This interface has been modified to have a 5V supply on the DB-9 connector. On this pin, you can draw a current of 300 [mA].
Modifications details
A wire has been added to place the USB voltage on DB-9 pin 9. A 0 [ohms] resistor has been added to connect the CAN_GND with the supply GND.
User DB-9 connector
Pin Nr. | Signal |
---|---|
1 | - |
2 | CAN-LOW |
3 | GND (both CAN & supply) |
4 | - |
5 | - |
6 | - |
7 | CAN-HIGH |
8 | - |
9 | USB 5V supply |
![DB-9 connector](/uit/images/thumb/9/9e/Db9M.jpg/100px-Db9M.jpg)