Hardware/FPGAEBS
(Difference between revisions)
m |
m |
||
Line 47: | Line 47: | ||
− | [[Category:Hardware]] | + | [[Category:Hardware]] [[Category:FPGAEBS]] |
Revision as of 14:10, 18 June 2012
|
There are several Version of FPGA EBS Boards
Type | FPGA-EBS Full board | FPGA-EBS Student board | FPGA-EBS Mezzanine | Schematic | UCF | Description |
---|---|---|---|---|---|---|
V2.1 | FPGA-EBS v2.1 Schematic PDF | FPGA-EBS v2.1 UCF Files | Improved second version of FPGA-EBS comes with Xilinx XC3S500e or XC3S1200E. Note that there is a different UCF Pin constraining file | |||
V2.0 | Not existing | FPGA-EBS v2.0 Schematic PDF | FPGA-EBS v2.0 UCF Files | Second FPGA-EBS Version comes only with Xilinx XC3S500E | ||
V1.0 | FPGA-EBS v1.0 Schematic PDF | Not available | First FPGA-EBS Version comes with a Xilinx XC2S150 or XC2S250 FPGA. Please note that for Spartan 2 is no longer supported by Xilinx, an ISE Version <= 9.2i has to be used |
A VHDL test code with the default UCF Files can be found at the EDA SVN Reopsitory
UCF Pin Differences
On the FPGA-EBS v2.X Boards, you can find two different FPGA Spartan3 Chips.
There are 3 Pin differences between Boards with XC3S500E and XC3S1200E.
Pin Function | Pin on XC3S500E | Pin on XC3S1200E |
---|---|---|
ParallelPort2(16) | F4 | E6 |
MezzanineData(9) | E17 | E3 |
sdCke | P15 | P15 |
Other changes between FPGA-EBS V2.0 and V2.1
There are some other changes made in the Ethernet part of those boards. Several bugs were changes and corrected.
- TCT and RCT Pins of the Ethernetconnector were strapped to 3.3V, and decoupled with Capacitors (C59 & C104)
- Serial Capacitors on the RX+ and RX- lines were replaced by 0Ohm Resistors (R61 & R63)
- Proper Reset circuit for the Ethernetphy is put on place (D13, D14, R62 & C108)