Hardware/8CH4IOHFAnalogMuxBoard
(Difference between revisions)
m |
m |
||
Line 6: | Line 6: | ||
= Characteristics = | = Characteristics = | ||
+ | [[File:MFS_ANALOGMUX_MEAS_200M_CH1IO1.png|thumb|CH1IO1 0..200MHz plot]] | ||
+ | [[File:MFS_ANALOGMUX_MEAS_8G_CH1IO1.png|thumb|CH1IO1 0..8GHz plot]] | ||
+ | [[File:MFS ANALOGMUX MEAS RELAYBW.PNG|thumb|Relays datasheet excerpt]] | ||
* 256x100mm 8 layers PCB | * 256x100mm 8 layers PCB | ||
* 8 <-> 1 channels | * 8 <-> 1 channels | ||
Line 16: | Line 19: | ||
* 1x LED per channel (light when selected) + 1x power LED. | * 1x LED per channel (light when selected) + 1x power LED. | ||
* 1x 2mm-pitched 2x6 connector. | * 1x 2mm-pitched 2x6 connector. | ||
− | |||
− | |||
− | |||
= Power supply / driving considerations = | = Power supply / driving considerations = |
Revision as of 12:03, 24 August 2016
|
This general purpose board was created for high quality analog muxing/demuxing for demanding measurement applications.
Characteristics
- 256x100mm 8 layers PCB
- 8 <-> 1 channels
- 4 I/O per channels (ground commuted with the signal, so no common ground)
- Bandwidth : 0...200MHz (best use : 0...10MHz, see plot below)
- SMA or SMB connectors
- Signal relay based solution
- Balanced tree routage (same trace distance for any commuted channel)
- 50Ohms impedance controlled shielded coaxial traces
- 1x LED per channel (light when selected) + 1x power LED.
- 1x 2mm-pitched 2x6 connector.
Power supply / driving considerations
This board doesn't have any driving circuit on it. The following signals can be found on the connector :