Hardware/CubeSat Gumstix/Test/ADC
(Difference between revisions)
(Created page with "{{TOC right}} The ADC controller design reads the 8 ADC channels together with the temperature value and sends the values to the serial port. The UART baud rate is 115˙200....") |
(→Measurements) |
||
Line 38: | Line 38: | ||
* 5C2<sub>h</sub> for the 1.8 V on channel 2 | * 5C2<sub>h</sub> for the 1.8 V on channel 2 | ||
* 3D7<sub>h</sub> for the 1.2 V on channel 4 | * 3D7<sub>h</sub> for the 1.2 V on channel 4 | ||
+ | |||
+ | = Gumstix = | ||
+ | |||
+ | Log-in to the Gumstix via the USB serial console with administrative rights. | ||
+ | |||
+ | List the possible serial ports: | ||
+ | ls -l /dev/tty* | ||
+ | |||
+ | [[Category:Hardware]] | ||
+ | [[Category:Cubesat]] | ||
+ | [[Category:Gumstix]] |
Revision as of 16:47, 26 October 2015
|
The ADC controller design reads the 8 ADC channels together with the temperature value and sends the values to the serial port.
The UART baud rate is 115˙200. The ADC sampling rate is 100 Hz, due to the slow UART text transmission. The ADC's SPI connection runs at 12.5 MHz (100 MHz / 4 / 2).
SPI
The ADC's SPI interface is mirrored on the peripheral 2 connector:
- CS_n pin 5
- SCLK pin 6
- MOSI pin 7
- MISO pin 8
- RST_N pin 9
- BUSY pin 10
Serial port
The serial data out is provided on the serial port to the Gumstix. It is mirrored on the peripheral 2 connector:
- GND pin 2
- TxD pin 3 (not used)
- RxD pin 4
The FTDI serial-USB adapter uses:
- GND: black
- TxD: orange
- RxD: yellow
Measurements
With a 5 V voltage reference, the reading should be:
- FFFh for the 5 V on channel 0
- A8Fh for the 3.3 V on channels 1 to 3
- 800h for the 2.5 V on channel 1
- 5C2h for the 1.8 V on channel 2
- 3D7h for the 1.2 V on channel 4
Gumstix
Log-in to the Gumstix via the USB serial console with administrative rights.
List the possible serial ports:
ls -l /dev/tty*