HiRel/CanSat/Slave XBee
From FSI
Revision as of 15:00, 27 May 2015 by Francois.corthay (Talk | contribs)
Type | CanSat Slave XBee | Schematic | Description |
---|---|---|---|
V1.0 | ![]() |
CanSat Slave XBee v1.0 Schematic PDF | XBP24BZ7UIT-004 |
The CanSat RF communication is done with the help of an
XBee-PRO ZB S2B module w/ U.Fl antenna connector.
The connection to the module is done through following pins:
name | pin | dir | description |
---|---|---|---|
data_in | b2 | in | serial link RxD |
data_out | b4 | out | serial link TxD |
reset_n | b6 | in | reset_n |
sleep_rq | b8 | in | sleep control |
RSSI_PWM | t1 | out | radio signal strength indication |
associate | t3 | out | association indication |
dio | t5 | inout | digital I/O |
sleep_n | t7 | out | sleep indicator |
An XBee module can work in API mode, providing a complete ZigBee network, or as a simple AT modem. In order to communicate between different modules, a common PAN identifier must be set. The XBee product manual gives the setup information.