Hardware/Parallelport/DAC2
From UIT
(Difference between revisions)
(→Two-Channel DAC board) |
m |
||
(2 intermediate revisions by one user not shown) | |||
Line 9: | Line 9: | ||
! Version || Photo || Schematics || Description | ! Version || Photo || Schematics || Description | ||
|- | |- | ||
− | | V1.0 || | + | | V1.0 ||[[File:PP_HEB_DAC.jpg|200px|HEB DAC]] || [[Media:PP_HEB_DAC_schematic.pdf|HEB DAC Schematic PDF]] || 2-Channel DAC parallelport board |
|} | |} | ||
Line 29: | Line 29: | ||
* Check the raw DAC voltage on the left side of each leftmost resistor. | * Check the raw DAC voltage on the left side of each leftmost resistor. | ||
* Check the voltage outputs of the board. | * Check the voltage outputs of the board. | ||
+ | |||
+ | [[File:PP_HEB_DAC_test.jpg|600px|Test of the PP HEB DAC Board]] | ||
+ | |||
[[Category:Hardware]] [[Category:Parallelport]] | [[Category:Hardware]] [[Category:Parallelport]] |
Latest revision as of 12:10, 12 June 2013
|
Two-Channel DAC board
The board bases on 2 AD5543 16-bit DACs. The DACs have a serial input (CS, CLK, SDI) and can be operated up to 3 MHz sampling rate with 0.5 µs settling time.
Version | Photo | Schematics | Description |
---|---|---|---|
V1.0 | ![]() |
HEB DAC Schematic PDF | 2-Channel DAC parallelport board |
The DACs have a current output and a first op-amp converts the currents to voltages. A second op-amp allows to set an offset and a gain with the help of resistors placed in through-hole pins.
The DACs are supplied with +5 V. The op-amps are supplied with ±12 V. These power supplies are generated from the parallel port connector's 3.3 V.
Test
Connect the board to the top connector of an FPGA development board.
Connect a 4-pieces rotary switch board to the lower connector of the FPGA board.
Download the sinewave
design.
- Check the power supplies: +12 V, -12 V, +5 V.
- Check the reference voltage: 10 V on pin 6 of the large chip in the middle of the 2 DAC rails.
- Check the digital serial signals on the FPGA board connector (pins TBD).
- Check the raw DAC voltage on the left side of each leftmost resistor.
- Check the voltage outputs of the board.