Components/IP/SD
(→Testbench) |
(→Sigma-Delta modulator) |
||
Line 42: | Line 42: | ||
The testbench generates a sinewave input to the modulator. | The testbench generates a sinewave input to the modulator. | ||
+ | Clock and signal frequencies are defined as constants in the top-level architecture and passed to the tester via generics. | ||
[[File:sigmaDeltaTestbench.png|700px]] | [[File:sigmaDeltaTestbench.png|700px]] | ||
The modulator output is fed to a lowpass filter which reconstructs the original signal. | The modulator output is fed to a lowpass filter which reconstructs the original signal. | ||
− | The lowpass | + | The lowpass we use also has a parameter <code>shiftBitNb</code> which can be used to shift the cutoff frequency octave by octave. |
+ | As a matter of fact, the testbench filter has the same structure as the sigma-delta modulator. | ||
+ | The only difference is that it hasn't a comparator at the output which reduces it to a single bit. | ||
[[Category:Components]] [[Category:Designs]] [[Category:VHDL]] [[Category:IP]] | [[Category:Components]] [[Category:Designs]] [[Category:VHDL]] [[Category:IP]] |
Revision as of 14:51, 14 June 2013
|
Sigma-Delta modulator
This IP can be found on the EDA Repository: svn: https://repos.hevs.ch/svn/eda/
The modulator architecture is of Cascaded Integrators with Distributed Feedback (CIDF).
Design
The coefficients can be chosen for the Signal Transfer Function (STF) to match any desired all-pole transfer function. This is done by writing the algebraic form of the modulator's STF and by comparing the denominator coefficients with the one of the desired transfer function. A Maxima script delivers the required coefficients.
An additional parameter, shiftBitNb
is used to ensure stability.
Adding 1 to shiftBitNb
reduces the STF by one octave (a factor of 2).
This value has to be adjusted within a simulation loop.
Entity
The VHDL entity of the modulator shows the generics, the inputs and the outputs:
ENTITY sigmaDeltaModulator IS GENERIC( signalBitNb : positive := 16; shiftBitNb : natural := 1 ); PORT( reset : IN std_ulogic; clock : IN std_ulogic; en : IN std_ulogic; parallelIn : IN signed (signalBitNb-1 DOWNTO 0); serialOut : OUT std_ulogic );
The en
would allow to work at a smaller frequency than the clock's.
As Sigma-Delta modulators should work at high rates, en
is usually set to 1.
Testbench
The testbench generates a sinewave input to the modulator.
Clock and signal frequencies are defined as constants in the top-level architecture and passed to the tester via generics.
The modulator output is fed to a lowpass filter which reconstructs the original signal.
The lowpass we use also has a parameter shiftBitNb
which can be used to shift the cutoff frequency octave by octave.
As a matter of fact, the testbench filter has the same structure as the sigma-delta modulator.
The only difference is that it hasn't a comparator at the output which reduces it to a single bit.