HiRel/CanSat/Master FPGA
Line 6: | Line 6: | ||
! Type || CanSat Master FPGA || Schematic || UCF || Description | ! Type || CanSat Master FPGA || Schematic || UCF || Description | ||
|- | |- | ||
− | | V1.0 || [[File: | + | | V1.0 || [[File:CanSat_Master_FPGA_with_pin_numbers.jpg|450px|CanSat Master FPGA V1.0]] || [[Media:P-CAD EDA - CanSat Master FPGA schematic.pdf|CanSat Master FPGA v1.0 Schematic PDF]] || [[TBD|CanSat Master FPGA v1.0 UCF Files]] || Spartan 6 XC6SLX9 and 8Mb M25P80 SPI PROM |
|- | |- | ||
|} | |} |
Revision as of 10:12, 24 May 2016
|
This board will be the master board on the HiRel/CanSat.
Type | CanSat Master FPGA | Schematic | UCF | Description |
---|---|---|---|---|
V1.0 | ![]() |
CanSat Master FPGA v1.0 Schematic PDF | CanSat Master FPGA v1.0 UCF Files | Spartan 6 XC6SLX9 and 8Mb M25P80 SPI PROM |
System
The design contains a soft-core processor controlling the different slaves of the CanSat via peripheral devices attached to it by an AHB-lite bus system.
Connections
The FPGA board hosts a 106.25 MHz oscillator and a button which can be used as a reset signal.
Signal | FPGA pin | FPGA dir |
---|---|---|
clock | 16 | in |
reset_n | 2 | in |
The FPGA board connectors consist of 4 dual Pmods, each having 12 pins. The Pmods are connected to the slave boards via the bottom and the top ring.
board | connector | Signal | Pmod pin | FPGA pin | FPGA dir |
---|---|---|---|---|---|
slave A: Radio |
bottom | RxD | J1.2 | 126 | out |
TxD | J1.4 | 123 | in | ||
reset_n | J1.6 | 119 | out | ||
sleep request | J1.8 | 117 | out | ||
top | RSSI PWM | J3.1 | 134 | in | |
associate | J3.3 | 138 | in | ||
DIO | J3.5 | 140 | inout | ||
sleep_n | J3.7 | 142 | in | ||
slave B: Sensors |
bottom | CS_n | J2.2 | 15 | out |
MOSI | J2.4 | 12 | out | ||
MISO | J2.6 | 9 | in | ||
SClk | J2.8 | 6 | out | ||
top | int_n | J4.1 | 24 | in | |
n.c. | J4.3 | 27 | |||
n.c. | J4.5 | 32 | |||
cnvt_n | J4.7 | 35 | out | ||
slave C: Power |
bottom | TxD | J1.1 | 127 | in |
RxD | J1.3 | 124 | out | ||
LED 0 | J1.5 | 121 | out | ||
LED 1 | J1.7 | 118 | out | ||
top | switch 3 | J3.2 | 133 | in | |
switch 2 | J3.4 | 137 | in | ||
switch 1 | J3.6 | 139 | in | ||
switch 0 | J3.8 | 141 | in | ||
slave D: Computer On Module |
bottom | RxD1 | J2.1 | 14 | out |
TxD1 | J2.3 | 11 | in | ||
GPIO 168 | J2.5 | 8 | out | ||
GPIO 167 | J2.7 | 5 | in | ||
top (analog audio) |
HSOLF | J4.2 | 23 | in | |
HSORF | J4.4 | 26 | in | ||
AUXRF | J4.6 | 30 | out | ||
AUXLF | J4.8 | 33 | out |
Configuration Flash
The FPGA has an attached M25P80 SPI flash of 8 Mb.
FPGA comparisons
The choice of the FPGA was based on a comparison of synthesis results of a simple AHB-Lite system.
Manufacturer | Device | Estimated Frequency | LUTs / CoreCells | Memory | ||
---|---|---|---|---|---|---|
[MHz] | % | Needed | Available | |||
Xilinx | XC6SLX9 | 75.3 | 807 | 13 | 4 | 32 |
Microsemi | AGL60 | 16.4 | 56896 | 3704 | 2 | 4 |
Microsemi | AGL250 |
As it is visible in the table above, the smaller Microsemi Igloo devices are too small. Bigger Microsemi Igloo devices however are not easily available and also quite expensive (>80$). On the other hand the Xilinx Spartan 6 FPGAs are quite spacious, immediately available and have a reasonable price (<20$). Furthermore we already use them successfully on our FPGArack board.
BOM
Device | DigiKey Part No | Description | Quantity |
---|---|---|---|
XC6SLX9-2TQG144C | 122-1745-ND | FPGA Xilinx Spartan 6 144TQF | 1 |
FT232RL | 768-1007-1-ND | FTDI IC USB FS SERIAL UART 28-SSOP | 1 |
SC189CSKTRT | SC189CSKCT-ND | DC-DC 3.3->1.2 | 1 |
10072354-G01-10ULF | 609-2961-ND | FPGA programmer connector | 1 |
CB3LV-3I-106M2500 | CTX718LVCT-ND | Oscillator 106.25MHz | 1 |
CB2518T1R0M | 587-2184-1-ND | INDUCTOR POWER 1.0uH 1007 | 1 |
M25P80-VMN6TP | M25P80-VMW6TGCT-ND | SPI Flash | 1 |
BLM18PG121SN1D | 490-1037-1-ND | Ferrite Chip 120 Ohm | 1 |
CC0805MKX5R5BB226 | 311-1464-1-ND | CAP CER 22uF 6.3V 20% X5R 0805 | 1 |
GRM21BR60J106ME19L | CAP CER 10uF 6.3V 20% X5R 0805 | 1 | |
08056D475KAT2A | 478-1416-1-ND | CAP 4.7uF 10% X5R 0805 | 14 |
C1608X5R1A474K080AA | 445-1320-1-ND | CAP 470nF 10% X5R 0603 | 10 |
Resistance 0603 10k | 2 | ||
Button | 2 |