Infrastructure/General Utilities/Wall-Mounted Screen
|
The big wall-mounted screen in the GridLab may be used in different ways. Those are explained here. To Power On the screen, use the command left below. To choose the source, select "SOURCE" on the command. To show something on the screen, take de remote control right. It's possible to start and forward a .ppt file with them too.
From the main PC
The main PC is this in front of the entry of Gridlab. To have him on the wall-mounted screen, select "PC" from source on the screen.
From another PC in Gridlab
The source must be selected on "HDMI-CEC raspberry" on the screen. Then on the PC, open the "TightVNC Service" down right and select "Attach Listening Viewer". The password is gridlab. Select "Attach" when the box with the IP adress opening. You have now your PC on the wall-mouted screen.
To stop or to give the using to another PC, go on the "TightVNC Service" and select "Disconnect All Viewers".
From a portable
Take off the 9pin Cable below from the main PC and plug him on your portable. Check on the wall-mouted screen if the source is "PC".
